Model 2094 Remote Control

Model 2094 Remote Control for 2092 is of the same rugged design, entirely made of die cast silicon bronze and stainless steel hardware and is backed with our usual warranty. This head comes with all the hardware to mount the interconnecting cables. These must be 47 series pull/pull cables.

The cable is attached with the clamps on the bottom of the supports of the control heads and the chain can be placed over the sprocket. When the control head is in the neutral position (handle in mid-position), the loose ends of the chain should be equally long on either side of the sprocket. 

The cable core is equipped with two nuts on either end. One of the nuts must be removed and the cable-end can be passed through the adapter link. The nut can now be reinstalled. 

It is also important to remember that the cable must be crossed between the control heads in order to get the handles to move in the same direction. (The forward cable from the master station is attached on the aft side of the remote station and the forward cable of the remote station is attached to the aft side of the master station.) The cables have enough thread at the end to allow balancing of the handles at both stations. This is best accomplished by placing the master station in the neutral position (handle straight up).

The adjusting nuts at the end of the cable can now be tightened or loosened as required to balance the handles. Over-tightening of the cable core will result in excessive friction and will make the control system very stiff and difficult to operate.